![]() ![]() STM32 is a 32-bit Flash microcontroller family developed by ST Microelectronics.The reference manual describes such a procedure in 18.5. A similar solution is to perform a Nack Read without Start Condition. ![]() A solution to this is toggling the clock 8 times and sending a stop condition. It happens that some I2C slave permanently pulls down SDA, after the I2C bus was interrupted during some transmission. (#) To check if target device is ready for communication, use the function HAL_I2C_IsDeviceReady() (#) For I2C IO and IO MEM operations, three operation modes are available within this driver : *** Polling mode IO operation *** = (+) Transmit in master mode an amount of data in blocking mode using HAL_I2C_Master_Transmit() (+) Receive. ![]() If you are not found for Stm32 Display, simply look out our info below. Of course, this code is also generated automatically. MX generated code will call Hal_ UART_ Mspinit () to initialize UART. ![]() Declare the initialization structure of UART and assign a value 2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |